VIBRO IPC 704 Signal conditioner

Description

The IPC 704 signal conditioner converts the chargebased signal from a piezoelectric-based transducer into a current or a voltage signal. This current or voltage signal is transmitted to the processing electronics via a standard 2-wire or 3-wire transmission cable.

The current modulation technique allows transmission over a distance of up to 1 km. A GSI galvanic separation unit is required for this configuration.

The electronic circuitry of the IPC 704 signal conditioner is incorporated into a moulded aluminium enclosure. The signal conditioner has configurable high-pass and low-pass filters and an optional integrator to give a velocity output. Furthermore, RFI filters protect the input and output against radiofrequency interference and other electromagnetic influences.

A range of installation options are available for the IPC 704 signal conditioner, including:

» A polyester enclosure providing environmental protection against dust, oil and water jets.

» A mounting adaptor allowing the IPC 704 signal conditioner to be mounted on a DIN rail.

Two versions of the IPC 704 signal conditioner are available:

» An IPC 704 for sensors using standard piezoelectric materials, for example, CA xxx, CP 10x and CP 2xx (ordering number 244-704-000-042-…).

» An IPC 704 for sensors using GaPO4 piezoelectric material, for example, CP 50x (ordering number 244-704-000-511-…).

FEATURES

» From the Vibro-Meter® product line

» For CA xxx piezoelectric accelerometers and CP xxx dynamic pressure sensors

» Configurable high-pass and low-pass filters » Frequency range: 0.5 Hz to 20 kHz

» Optional integrator to produce a velocity output

» Optional 2-wire current or 3-wire voltage transmission

» Certified for use in potentially explosive atmospheres

» A range of installation options are available

Stock part list:

Post time: Dec-11-2025