page_banner

products

Honeywell 51400756-100 Rev M Honeywell Membrane Keyboard

short description:

Item no:51400756-100

brand:Honeywell

price:$1200

Delivery time: In Stock

Payment: T/T

shipping port: xiamen


Product Detail

Product Tags

Description

Manufacture Honeywell
Model 51400756-100
Ordering information 51400756-100
Catalog FTA
Description Honeywell 51400756-100 Rev M Honeywell Membrane Keyboard
Origin USA
HS Code 3595861133822
Dimension 3.2cm*10.7cm*13cm
Weight 0.3kg

 

Details

The desk-side Universal Work Station is protectively wrapped and shipped in a doublewall pack. Its peripherals are packaged separately. Refer to publications listed under subsection 1.2 for installation of BASIC System equipment and UCN Subsystem equipment such as: • Multifunction Controller (MC) • Advanced Multifunction Controller (A-MC) • Process Interface Units (PIU) • Process Manager (PM) • Advanced Process Manager (APM) • Logic Manager (LM) • Operator Stations • Data Hiway/Fiber Optic cabling • Hiway Gateway (HG) cabling • Network Interface Module (NIM) cabling • Process I/O-signal wiring An overview drawing of HG preferred-access cabling is presented in Appendix A. 2.2 PRELIMINARY SITE INSPECTION Inspect the area in which the equipment is to be installed—refer to the "Preparedness Checklist" in Section 6 of the LCN Site Planning manual. Check the route from the delivery point to the final destination for adequate space through hallways, doors, and around corners. If, for example, the Universal Station cannot negotiate a narrow hallway or tight corner, it may be necessary to remove the keyboard/panel or table-top assembly before it can be moved into place. Also, the trend-pen recorder option, mounted above the CRT shroud, adds approximately two inches to the overall width (front-to-back). See Appendix A for removal/replacement procedure. LCN equipment cabinets and the Universal Work Station do not have leveling pads and are designed to be installed on a level floor. Make sure the floor is level before moving the equipment into place. Note that LCN equipment cabinets are not designed for eye-bolt lifting. If cabling is to be run under the false floor, do so before the cabinet is moved into place. Cabinets can be bolted to the floor, if required. Holes are provided in each corner of the base. 2.3 STORAGE If LCN equipment cabinets, Universal Stations, Universal StationXs, Universal Work Stations, and peripherals are to be placed in storage, the environmental constraints specified in the LCN Site Planning manual, Table 2-1, must be followed, with particular emphasis on relative humidity and airborne contaminants.

51400756-100(1)

51400756-100(2)

51400756-100


  • Previous:
  • Next:

  • Send your message to us: